Avaya 3500 Series Getting Started page 68

Configuring the switch using ACLI
Variable definitions
The following table describes the parameters for the show interfaces command.
Variable
admin-disabled
admin-enabled
gbic-info
link-down
link-up
names
verbose
<portlist>
Displaying interface configurations
Use this procedure to display the current configuration of all interfaces or for a specific port.
The configuration of all port interfaces on the switch or stack can be viewed, including port
configuration, VLAN interface, VLAN port member, and Spanning-Tree configuration.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show interfaces <portlist> config
Example
The following figure provides a sample of the show interfaces config command.
switch>show interfaces 1/1 config
Unit/Port: 1/1
Trunk:
Admin Status: Enable
Oper Status:
EAP Oper Status: Up
VLACP Oper Status:
STP Oper Status:
Link: Up
LinkTrap: Enabled
Link Autonegotiation:
Link Speed:
Link Duplex:
Flow Control:
BPDU-guard (BPDU Filtering): Disabled
BPDU-guard (BPDU Filtering): Oper Status: N/A
*****VLAN interfaces configuration*****
Filter
Untagged Unregistered
Unit/Port Frames
--------- -------- ------------ ---- --- ------------- ----------------
1/1 No
Getting Started with Avaya ERS 3500 Series
68
Up
Down
Forwarding
Enabled
100Mbps
Full-Duplex
Disable
Filter
Frames PVID PRI
Yes 1 0
Comments on this document? infodev@avaya.com
Value
Displays the interfaces with administration disabled.
Displays the interfaces with administration enabled.
Displays Gigabit Interface Converter (GBIC) details.
Displays the interfaces with link down.
Displays the interfaces with link up.
Displays the interface names.
Displays full information about each port.
Specifies the ports that you want to display.
Tagging Name
UntagAll Unit 1,Port 1
July 2015