Avaya 3500 Series Getting Started page 48

Configuring Telnet
Variable
logging none | access | failures | all
source-ip <1–10> <A.B.C.D>[mask <A.B.C.D>]
no telnet-access [source-ip [<1–10>]]
Getting Started with Avaya ERS 3500 Series
48
Value
Specifies what types of events you want to save in
the event log:
• All — Saves all access events in the log:
• none — No Telnet events are saved in the event
• access — Connect and disconnect events are
• failure — Only failed Telnet connection attempts
Specifies up to 10 IP address from which
connections are allowed. Enter the IP address either
as an integer or dotted-decimal notation (A.B.C.D in
the format XXX.XXX.XXX.XXX).
Specifies the subnet mask from which connections
are allowed; enter the IP mask in dotted-decimal
notation (A.B.C.D in the format XXX.XXX.XXX.XXX)
Disables the Telnet connection. When you do not
use the optional parameter, the source-up list is
cleared, meaning that the 1st index is set to
0.0.0.0/0.0.0.0 and the 2nd to 10th indexes are set to
255.255.255.255/255.255.255.255. When you do
specify a source-ip value, the specified pair is set to
255.255.255.255/255.255.255.255.
Comments on this document? infodev@avaya.com
- Telnet connect — indicates the IP address and
access mode of a Telnet session
- Telnet disconnect — indicates the IP address of
the remote host and the access mode, due to
either a log off or inactivity.
- Failed Telnet connection attempts — indicates
the IP address of the remote host that is not on
the list of allowed addresses, or indicates the IP
address of the remote host that did not supply
the correct password.
log.
saved in the event log.
are saved in the event log.
Important:
These are the same source IP addresses as in
the IP Manager list. For more information about
the IP Manager list, see Configuring Security on
Avaya Ethernet Routing Switch 3500 Series,
NN47203–504.
Table continues...
July 2015