Advertisement
TMP96C141AF
6. Port Section Equivalent Circuit Diagram
• Reading The Circuit Diagram
Basically, the gate singles written are the same as
those used for the standard CMOS logic IC [74HCXX]
series.
The dedicated signal is described below.
• PO (AD0 ~ AD7), P1 (AD8 ~ 15, A8 ~ 15), P2 (A2 - 23, A0 ~7)
• P30 (RD), P31 (WR)
• P32 ~ 37, P40 ~ 41, P6, P7, P80 ~ 86, P91 ~ 92, P94 ~ 95
174
STOP: This signal becomes active "1" when the hold mode
setting register is set to the STOP mode and the CPU
executes the HALT instruction. When the drive enable
bit [DRIVE] is set to "1", however, STP remains at "0".
• The input protection resistor ranges from several tens of
ohms to several hundreds of ohms.
TOSHIBA CORPORATION
Advertisement
