Key Digital KD-IP1080Tx Manual page 80

1. Before Titan Networx network switch is configured Key Digital KD-IP120/KD-IP1080 HDMI switch set must
be connected to all HDMI sources/displays/network switches, and configured using Key Digital KD-IP120
Key Digital Management Software latest version.
2. Power-up all the system components. Using Key Digital KD-IP120 Key Digital Management Software, switch
All Outputs -> Through at switching page.
3. IMPORTANT: Disconnect all the DHCP devices like routers, servers from the Linksys network switch.
4. Locate a pinhole "RESET" button at the front panel left bottom corner of your Titan Networx network
switch. Using a paper clip press and hold a reset button for more than 10 seconds and then release. Wait
while the device is restarted and ready to use (about 5min).
5. IMPORTANT: At this point all the displays should be displaying distorted randomly flashing video images.
6. Connect your PC to the Titan Networx network switch directly using a network cable.
7. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.1.xxx).
8. Enter the switch's IP address in your browser and press ENTER (check the user manual for a default IP
address – usually, it is: 192.168.1.30).
9. Enter user name and password (check the user manual for a default user name and password; it is usually
"admin" for both). Then click Log In.
10. Navigate to Administration -> System Configuration. Select IP Address box. IP address can be changed by
the administrator depending on the network configuration. If you are using multiple network switches it is
recommended to set first one to 192.168.1.251, second to 192.168.1.252, and so on (we will change an IP
IGMP Setup Guide: Titan Networx
1080p Systems (KD-IP1080, KD-IP120)
80 | P a g e