Key Digital KD-IP1080Tx Manual page 17

Note: Compatible with KD-IP1080, KD-IP120 Enterprise AV Systems Only
1. Before Cisco network switch is configured Key Digital KD-IP120/KD-IP1080 HDMI switch set must be
connected to all HDMI sources/displays/network switches, and configured using Key Digital KD-IP120 Key
Digital Management Software latest version.
2. Power-up all the system components. Using Key Digital KD-IP120 Key Digital Management Software, switch
All Outputs -> Through at switching page.
3. IMPORTANT: Disconnect all the DHCP devices like routers, servers from the Cisco network switch.
4. Locate a pinhole "RESET" button at the front panel left bottom corner of your Cisco network switch. Using a
paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
5. IMPORTANT: Make sure the green "SYSTEM"LED next to the pinhole "RESET" button is flashing.
6. IMPORTANT: At this point all the displays should be displaying distorted randomly flashing video images.
7. Connect your PC to the Cisco network switch directly using a network cable.
8. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.1.xxx).
9. Enter the switch's IP address in your browser and press ENTER (check the user manual for a default IP
address - it is usually 192.168.1.254).
10. Enter user name and password (check the user manual for a default user name and password; it is usually
"cisco" for both). Then click Log In.
IGMP Setup Guide: Cisco SF500-48
1080p Systems (KD-IP1080, KD-IP120)
17 | P a g e