Key Digital KD-IP1080Tx Manual page 12

1. Before Araknis network switch is configured Key Digital KD-IP120/KD-IP1080 HDMI switch set must be
connected to all HDMI sources/displays/network switches, and configured using Key Digital KD-IP120 Key
Digital Management Software latest version; refer to Key Digital KD-IP120/KD-IP1080 configuration manual.
2. Power-up all the system components. Using Key Digital KD-IP120 Key Digital Management Software, switch
All Outputs -> Through at switching page.
3. IMPORTANT: Disconnect all the DHCP devices like routers, servers from the Araknis network switch.
4. Locate a pinhole "RESET" button at the front panel left bottom corner of your Araknis network switch. Using
a paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
5. IMPORTANT: At this point all the displays should be displaying distorted randomly flashing video images.
6. Connect your PC to the Araknis network switch directly using a network cable.
7. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.20.xxx).
8. Enter the switch's IP address (default is 192.168.20.254) in your browser and press ENTER.
9. Enter user name and password (default is "araknis" for both). Then click Log In.
IGMP Setup Guide: Araknis
4K Systems (KD-IP922)
12 | P a g e