Key Digital KD-IP1080Tx Manual page 56

1. Before Linksys network switch is configured Key Digital KD-IP922 HDMI switch set must be connected to all
HDMI sources/displays/network switches, and configured using Key Digital Management Software latest
version.
2. Power-up all the system components. Using Key Digital Management Software, switch All Outputs ->
Through at switching page.
3. IMPORTANT: Disconnect all the DHCP devices like routers, servers from the Linksys network switch.
4. Locate a pinhole "RESET" button at the front panel left bottom corner of your Linksys network switch. Using
a paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
5. IMPORTANT: Make sure the blue "SYSTEM"LED next to the pinhole "RESET" button is flashing.
6. IMPORTANT: At this point all the displays should be displaying or flashing Key Digital logo with information
stamp.
7. Connect your PC to the Linksys network switch directly using a network cable.
8. If you have not done yet, configure your PC's IP address to the same range as the switch (default
192.168.1.xxx).
9. Enter the switch's IP address in your browser and press ENTER (check the user manual for a default IP
address - it is usually 192.168.1.251).
10. Enter user name and password (check the user manual for a default user name and password; it is usually
"admin" for both). Then click Log In.
IGMP Setup Guide: Linksys
4K Systems (KD-IP922)
56 | P a g e