Completing The Setup: Learning; Product; More About Your Product - Toro 41177 Multi-Pro 1250 Operator's Manual

the time of manufacture to allow the booms to
be in this position for transit. Before operating
the machine, the springs must be adjusted to the
correct compression.
1. If necessary, remove the packing components
that secure the right and left extension booms
during shipping.
2. Support the booms while they are extended
to the spray position.
3. At the boom hinge, measure the compression
of the upper and lower springs while the booms
are in their extended position (Figure 8).
A. All springs must be compressed until they
measure 1.56 inches.
B. Use the jam nut to compress any spring
that measure greater than 1.56 inches.
Figure 8
1. Boom hinge spring
4. Repeat the procedure for each spring on both
boom hinges.
5. Move the booms into the transport "X"
position. See Operating the Booms in
Operation, page 25 for more information.
2. Jam nut
Step
4
Completing the Setup:
Learning more about your

product.

Parts needed for this step:
1 Ignition key
1 Operator's Manual
1
Engine Operator's Manual
1 Parts Catalog
1 Operator Training Material
1
Registration Card
1 Pre-delivery Inspection Sheet
Procedure
1. Read the manuals.
2. View the Operator training material.
3. Complete the registration card and return to
Toro.
4. Store the documentation in a safe place.
16