Danfoss VLT HVAC Basic Drive FC 101 Quick Manual page 32
Hide thumbs
Also See for VLT HVAC Basic Drive FC 101:
- Design manual (132 pages) ,
- Programming manual (124 pages) ,
- Operating manual (84 pages)
Table of Contents
Advertisement
Quick Guide
1
1
To change parameter settings
1.
Press [Menu] key to enter the Quick Menu until
indicator in display is placed above Quick Menu.
2.
Press [
motor setup or changes made, then press [OK].
3.
Press [
in the Quick Menu.
4.
Press [OK] to select a parameter.
5.
Press [
setting.
6.
Press [OK] to accept the change.
7.
Press either [Back] twice to enter "Status", or
press [Menu] once to enter "Main Menu".
The Main Menu accesses all parameters.
1.
Press [Menu] key until indicator in display is
placed above "Main Menu".
2.
Press [
groups.
3.
Press [Ok] to select a parameter group.
4.
Press [
in the specific group.
5.
Press [Ok] to select the parameter.
6.
Press [
30
VLT
▲
▼
] [
] to select wizard, closed loop setup,
▲
▼
] [
] to browse through the parameters
▲
▼
] [
] to change the value of a parameter
▲
▼
] [
] to browse through the parameter
▲
▼
] [
] to browse through the parameters
▲
▼
] [
] to set/change the parameter value.
®
HVAC Basic Drive FC 101 Quick Guide
MG18A502 - Rev. 2013-08-09
Advertisement
Table of Contents
