Changing Select Menu Values - IBM 3164 ASCII Manual

Chapter 4. Operations
-"'~'~---------"-----------
Changing SELECT menu values
4-8
If you want to change some other operating conditions besides those on the
Setup menu, you can do so using the Select menus 1 , 2, and 3. Press the
Select key, and the Select menu will appear at the bottom of the screen. The
defau It or the previously set values will appear. Go to a field you want to
change by using the Cursor Right (
~
) key and press the spacebar to get the
value you want. If you want to cancel these values or to exit from this menu,
press the Select key. These values can be changed even during an on-line
operation.
The select values can also be changed by the Set Control command from the
host system. For more information on these commands, refer to "Commands
and responses" in chapter 5.
The figure below shows the Select menus
1 , 2,
and
3.
SELECT:
fNTER-RETURN RETURN-FIELD NEW UNf-CR TAB-FIELD UNf WIAP-Oll
AUTO LF=ON SEND-PAGE HND NUU-ON 'NSERT=MODE TRACE-All CRT SAVER-NO
SCROLL-JUMP PRINT-PAGE PRINT NULL=ON PRINT EOl-ON LINE END=CR·lf
You can change these values also from the host system using the Set Control
commands.
The chart on the following page shows the field with their values.
(
(