Table of Contents
Advertisement
Setting Non Interlaced Mode
The monitor does not support interlace mode. If the video settings of your
IBM PC specify interlace mode, change them with the following steps:
1.
Turn on the monitor.
2.
Turn on your PC.
3.
Press F1 while the message 'Press F1 for configuration/setup' is being
displayed.
4.
Select Device and I/O in the Device Configuration Utility.
5.
Select Setup Video.
6.
Set the display type to Customize and the refresh rate to 60Hz or 75Hz.
7.
Press ESC three times.
8.
Select Save and Exit.
9.
Non Interlaced mode has been set.
18
Advertisement
Table of Contents
