A/D Conversion Enable/Disable Setting (Buffer Memory Address 0: Un\G0) - Mitsubishi MELSEC Q Series User Manual

3 SPECIFICATIONS

3.4.2 A/D conversion enable/disable setting (buffer memory address 0: Un\G0)

3 - 51
(1) Sets whether the output of an A/D conversion value is enabled or disabled for
each channel.
For the Q62AD-DGH, the A/D conversion enable/disable setting also acts as the
ON/OFF setting of the power supply to the 2-wire transmitter.
(2) It is necessary to set the operating condition setting request (Y9) to ON/OFF in
order to enable the A/D conversion enable/disable setting. (See Section 3.3.2.)
(3) The Q64AD-GH defaults to A/D conversion enable on all channels.
(4) The Q62AD-DGH defaults to A/D conversion disable on all channels.
b15 b14 b13 b12 b11 b10
0 0 0 0
For Q64AD-GH, information of b4 to b15 is fixed at 0.
For Q62AD-DGH, information of b2 to b15 is fixed at 0.
[Setting example of Q64AD-GH]
When the channels using A/D conversion are 1 and 3, 000A
the buffer memory address 0 (Un\G0).
b15 b14 b13 b12 b11 b10
0 0 0 0
0
[Setting example of Q62AD-DGH]
When the channels using A/D conversion are 1 and 2, 0000
the buffer memory address 0 (Un\G0).
b15 b14 b13 b12 b11 b10
0 0 0 0
0
b9 b8 b7
0 0 0 0 0
Q62AD-DGH
b9 b8 b7
0 0 0 0 0
0
b9 b8 b7
0 0 0 0 0
0
b6 b5 b4 b3 b2
0 0 0 CH4 CH3 CH2 CH1
0: A/D conversion enable
Q64AD-GH
1: A/D conversion disable
0: A/D conversion enable, power supply ON
1: A/D conversion disable, power supply OFF
(10) is stored into
H
b6 b5 b4 b3 b2
0 0 0 1 0
CH4 CH3 CH2 CH1
0 A
(0) is stored into
H
b6 b5 b4 b3 b2
0 0 0 0 0
0
MELSEC-Q
b1 b0
b1 b0
000A (10)
1 0
H
b1 b0
0 0 0000 (0)
H
CH2 CH1
0
3 - 51