Memory Groups; Choosing The Desired Memory Group - Yaesu FTDX101D Operation Manual

Memory Groups

Memory channels may be listed into as many
as six convenient groups, for easy identification
and selection. For example: groups for AM BC
stations, Short-wave broadcast stations, Contest
frequencies, Repeater frequencies, PMS limits, or
any other desired grouping may be created.
Each memory group may hold up to 20 memo-
ry channels (except Memory Group 01 which is
limited to 19 memory channels). When memory
channels are grouped, the channel numbers
change to correspond to the chart below:
Memory
01 - 99
P1L/1U - P9L/9U
Group 1 Group 2 Group 3
Memory Memory Memory
Channel Channel Channel
1 - 19 20 - 39 40 - 59
1. Press the [FUNC] key.
2. Select [OPERATION SETTING]→[GENER-
AL]→[MEM GROUP].
3. Select [ON].
4. Press the [FUNC] key to save the new setting
and exit the Setting Menu.
5. Press the [FUNC] key to exit to normal operation.
● To cancel Memory Group operation, repeat
steps 1 through 5 above, choosing "OFF" in
step 3.
Group 4 Group 5 Group 6
Memory Memory Memory
Channel Channel Channel
P1L/1U
60 - 79 80 - 99
P9L/9U
Choosing the Desired
Memory Group
If desired, just the memories listed within a partic-
ular Memory Group, may be recalled.
Before performing the operation, set the "MEM
GROUP" menu to "ON" (Refer to "Memory
Groups" setting on the left).
1. Press the [V/M] key, if necessary, to enter the
"Memory" mode.
2. Press the [FUNC] key.
3. Touch [GROUP].
4. Rotate the [MULTI] knob to select the desired
Memory Group, then press the [MULTI] knob.
5. Press the [FUNC] key, then touch [MEM CH].
6. Rotate the [MULTI] knob to select the desired
Memory Channel within the Selected Memory
Group.
71