Checking The Cw Memory Contents; On-The-Air Cw Message Playback - Yaesu FTDX101D Operation Manual

• CHECKING THE CW MEMORY
CONTENTS
1. Be sure that Break-in is still turned "OFF" by
the [BK-IN] key.
2. Press the [MONI] key to enable the CW mon-
itor.
When using FH-2, go to step 5.
3. Press the [FUNC] key.
4. Touch [REC/PLAY] .
5. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, whichever memory was just
recorded. The message will be played and
heard in the sidetone monitor, but no RF en-
ergy will be transmitted.
● The "MSG" and "PLAY" icon will appear in
the display.
● To adjust the volume level during playback,
press and hold the [MONI] key then rotate
the [MULTI] knob.
58
● ON-THE-AIR CW MESSAGE PLAYBACK
1. Press the [BK-IN] key to enable transmission.
When using FH-2, go to step 4.
2. Press the [FUNC] key.
3. Touch [REC/PLAY] .
4. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, to transmit the recorded
CW Memory Register message. The pro-
grammed message will be transmitted on the
air.
● During a transmission, the same key may
be pressed again to immediately end the
transmission.
Transmitting in the Beacon Mode
In "Beacon" mode, any programmed mes-
sage, (either via Paddle, or via "Text" input
method) may be repeatedly transmitted.
The time delay between message repeats
may be set from 1 to 60 seconds, in one
second steps, via Menu item "REPEAT IN-
TERVAL".
To transmit the message:
1. Touch and hold [1] - [5] on the display
or press and hold the FH-2 [1] - [5] key.
Repetitive transmission of the Beacon
message will begin.
2. Press the same key again to cancel the
Beacon Mode.