Yaesu FTDX101D Operation Manual page 90

RPTT SELECT
Function: Sets the PTT control for the FM trans-
mit signal.
Available Values: DAKY / RTS / DTR
Default Setting: DAKY
Description:
DAKY: Controls the FM transmit signal from the
RTTY/DATA jack (pin 3) on the rear panel.
DTR: Controls the FM transmit signal from the
USB virtual COM/DTR ports.
RTS: Controls the FM transmit signal from the
USB virtual COM/RTS ports.
RPT SHIFT(28MHz)
Function: Sets the RPT offset frequency on the
28 MHz band.
Available Values: 0 - 1000 kHz
Default Setting: 100 kHz
Description: The RPT offset frequency can be set
at 10 kHz increments between 0 kHz
and 1000 kHz.
RPT SHIFT(50MHz)
Function: Sets the RPT offset frequency on the
50 MHz band.
Available Values: 0 - 4000 kHz
Default Setting: 1000kHz
Description: The RPT offset frequency can be set
at 10 kHz increments between 0 kHz
and 4000 kHz.
88
RADIO SETTING
- MODE PSK/DATA -
AGC FAST DELAY
Function: Sets the AGC-FAST DELAY voltage
decay characteristics for PSK/DATA
mode.
Available Values: 20 - 4000msec
Default Setting: 160msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
AGC MID DELAY
Function: Sets the AGC-MID DELAY voltage
decay characteristics for PSK/DATA
mode.
Available Values: 20 - 4000msec
Default Setting: 500msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
AGC SLOW DELAY
Function: Sets the AGC-SLOW DELAY voltage
decay characteristics for PSK/DATA
mode.
Available Values: 20 - 4000msec
Default Setting: 1500msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
PSK TONE
Function: Set the PSK tone
Available Values: 1000 / 1500 / 2000 Hz
Default Setting: 1000 Hz
DATA SHIFT (SSB)
Function: Sets the carrier point in DATA mode.
Available Values: 0 - 3000 Hz
Default Setting: 1500 Hz
Description: The frequency can be set in steps of
10 Hz.
LCUT FREQ
Function: Sets the low-frequency cutoff audio fil-
ter in DATA mode.
Available Values: OFF / 100Hz - 1000Hz
Default Setting: 300
Description: The cutoff frequency can be set at
50 Hz increments between 100 Hz
and 1000 Hz.