Memory Operation; Memory Storage; Erasing Memory Channel Data - Yaesu FTDX101D Operation Manual

Memory Operation

V M
u

• Memory Storage

1. Set the frequency, mode, and status, as de-
sired.
2. Press the [V M] key.
u
The memory channel list will be displayed.
3. From the channel list, touch and select the
desired memory channel
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
4. Press and hold the [V
frequency and other data into the selected
memory channel.
● This method may also be used to overwrite
the contents previously stored to a memory
channel.
5. Press the [V M] key, the memory is stored
u
and the screen returns normal.
The information saved in the memory may
be lost due to incorrect operation, static
electricity or electrical noise. Data may also
be lost due to component failures and re-
pairs. Make sure to write down the informa-
tion registered in the memories on a piece of
paper or by using a SD card (page 77).
68
M] key to store the
u

• Erasing Memory Channel Data

The contents written to the memory channel may
be erased.
1. Press the [V M] key.
u
The memory channel list will be displayed.
2. From the channel list, touch and select the
memory channel to be erased.
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
3. Touch [ERASE] to clear the contents of the
selected memory channel.
4. Press the [V M] key to erase the contents of
u
the selected memory channel.
If you make a mistake and wish to restore a
memories contents, touch [RESTORE].
Memory channels "M-01" (and "5-01"
through "5-10": U.S. version) cannot be
erased.