Page 2
1200 computer before using the SCU-17 USB interface unit. Please see the USB Driver (Virtual COM Port Driver) on the Yaesu Website for details refer to (http://www. yaesu.com/) in the FT 1200 product files section. Note: Do not connect the USB cable and SCU-17 to your personal computer until after the “virtual...
Page 3
perATion ompuTer ided rAnsCeiver ontrol ommand A computer control command is composed of an alpha- Parameters betical command, various parameters, and the terminator Parameters are used to specify information necessary to that signals the end of the control command. implement the desired command. Example: Set the VFO-A frequency to 14.250000 MHz.
Page 4
perATion ompuTer ided rAnsCeiver Function ommand ommand unCtion VFO-A TO VFO-B PLAY BACK ANTENNA TUNER CONTROL POWER CONTROL AF GAIN SPEECH PROCESSOR LEVEL AUTO INFORMATION SPEECH PROCESSOR VFO-A TO MEMORY CHANNEL POWER SWITCH ANTENNA NUMBER QMB STORE VFO-B TO VFO-A QMB RECALL AUTO NOTCH QUICK SPLIT...
perATion ompuTer ided rAnsCeiver POWER SWITCH P1 0: POWER “OFF” 1: POWER “ON” Read This command requires dummy data be initially sent. Then after one second and before two seconds the command is sent. Answer QMB STORE Read Answer QMB RECALL Read Answer QUICK SPLIT...
Page 18
perATion ompuTer ided rAnsCeiver TX SET P1 0: RADIO TX “OFF” CAT TX “OFF” 1: RADIO TX “OFF” CAT TX “ON” 2: RADIO TX “ON” CAT TX “OFF” (Answer) Read Answer PLL UNLOCK STATUS P1 0: PLL “Lock” 1: PLL “Unlock” Read Answer Read...
Page 19
perATion ompuTer ided rAnsCeiver TX CLAR P1 0: TX CLAR “OFF” 1: TX CLAR “ON” Read Answer ZERO IN (CW AUTO ZERO IN Function) Read :requires FFT-1 (option) Answer 1200 CAT Operation Manual...
Page 20
Copyright 2013 YAESU MUSEN CO., LTD. All rights reserved No portion of this manual may be reproduced without the permission of 1310-B0 YAESU MUSEN CO., LTD.