Checking The Cw Memory Contents; On-The-Air Cw Message Playback - Yaesu FTDX101D Operation Manual

• Checking the CW Memory Contents

1. Set the operating mode to CW.
2. Be sure that Break-in is still turned "OFF" by
the [BK-IN] key.
3. Press the [MONI] key to enable the CW mon-
itor.
When using the optional FH-2, go to step 6.
4. Press the [FUNC] key.
5. Touch [REC/PLAY] .
6. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, whichever memory that was
recorded in. The message will be played, and
heard in the sidetone monitor, but no RF en-
ergy will be transmitted.
● The "MSG" and "PLAY" icons will appear in
the display.
● To adjust the playback volume level, press
and hold the [MONI] key then rotate the
[MULTI] knob
If "#" is entered in the CW message, the contest number will automatically increment (count up) each
time the message is sent. See below to set the contest number.
Contest Number Programming
1. Press the [FUNC] key.
2. Select [CW SETTING] → [KEYER] → [CONTEST NUMBER].
3. Rotate the [MULTI] knob to set the Contest Number to the desired value.
4. Press the [FUNC] key to save the new setting and exit the Setting Menu.
5. Press the [FUNC] key to exit to normal operation.
Decrementing the Contest Number
Use this process if the current contest number gets ahead of the actual number. For example: in case
of a duplicate QSO,).
Press the FH-2 [DEC] key momentarily. The current Contest Number will be reduced by one. Press of
the FH-2 [DEC] key as many times as necessary to reach the desired number. If you go too far, use
the "Contest Number Programming" technique described above.
60

• ON-THE-AIR CW Message PLAYBack

1. Press the [BK-IN] key to enable transmission.
When using FH-2, go to step 4.
2. Press the [FUNC] key.
3. Touch [REC/PLAY] .
4. Touch [1] - [5] on the display or press the
FH-2 [1] - [5] key, depending on the CW
Memory Register message to be transmitted.
The programmed message will be trans- mit-
ted on the air.
● During transmission, press the same key
again, to immediately cancel the transmis-
sion.
Transmitting in the Beacon Mode
In "Beacon" mode, any programmed mes-
sage, (either via Paddle, or via "Text" input
method) may be repeatedly transmitted.
The time delay between message repeats
may be set from 1 to 60 seconds, in one
second steps, via Menu item "REPEAT IN-
TERVAL".
To transmit the message:
1. Touch and hold [1] - [5] on the display
or press and hold the FH-2 [1] - [5] key.
Repetitive transmission of the Beacon
message will begin.
2. Press the same key again to cancel the
Beacon Mode.
Contest Number