Yaesu FTDX101D Operation Manual page 89

RADIO SETTING
- MODE FM -
AGC FAST DELAY
Function: Sets the AGC-FAST DELAY voltage
decay characteristics for FM mode.
Available Values: 20 - 4000msec
Default Setting: 160msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
AGC MID DELAY
Function: Sets the AGC-MID DELAY voltage de-
cay characteristics for FM mode.
Available Values: 20 - 4000msec
Default Setting: 500msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
AGC SLOW DELAY
Function: Sets the AGC-SLOW DELAY voltage
decay characteristics for FM mode.
Available Values: 20 - 4000msec
Default Setting: 1500msec
Description: Sets the AGC voltage decay char-
acteristics in 20 msec steps after
the input signal level becomes lower
than the AGC detection level and the
HOLD time has expired.
LCUT FREQ
Function: Sets the low-frequency cutoff audio fil-
ter in FM mode.
Available Values: OFF / 100Hz - 1000Hz
Default Setting: 300
Description: The cutoff frequency can be set at
50 Hz increments between 100 Hz
and 1000 Hz.
LCUT SLOPE
Function: Sets the slope of the low-frequency
cutoff audio filter in FM mode.
Available Values: 6dB/oct / 18dB/oct
Default Setting: 18dB/oct
HCUT FREQ
Function: Sets the high-frequency cutoff audio
filter in FM mode.
Available Values: 700Hz - 4000Hz/OFF
Default Setting: 3000Hz
Description: The cutoff frequency can be set at
50 Hz increments between 700 Hz
and 4000 Hz.
HCUT SLOPE
Function: Sets the slope of the high-frequency
cutoff audio filter in FM mode.
Available Values: 6dB/oct / 18dB/oct
Default Setting: 18dB/oct
FM OUT SELECT
Function: FM signal output band setting from
RTTY/DATA jack.
Available Values: MAIN / SUB
Default Setting: MAIN
Description: Select the band to output the FM
signal.
FM OUT LEVEL
Function: Sets the level of the receive FM signal
output from the RTTY/DATA jack.
Available Values: 0 - 100
Default Setting: 50
FM MOD SOURCE
Function: Selects the microphone input jack for
FM mode.
Available Values: MIC / REAR
Default Setting: MIC
Description:
MIC: Audio is input from the MIC jack on the
front panel.
REAR: Disables the microphone circuit on the
front panel and inputs audio/data from the
USB jack or RTTY/DATA jack on the rear
panel.
MIC GAIN
Function: Sets the microphone gain for the FM
mode.
Available Values: MCVR / 0 - 100
Default Setting: MCVR
Description:
MCVR: Adjust the microphone gain (0 - 100) us-
ing the front panel [MIC/SPEED] knob.
0 - 100: Fixed to the set value.
REAR SELECT
Function: Selects the input jack of the FM signal.
Available Values: DATA / USB
Default Setting: DATA
Description: Selects the input jack of the FM sig-
nal when "FM MOD SOURCE" is set
to "REAR".
DATA: Inputs from the RTTY/DATA jack on the
rear panel.
USB: Inputs from the USB jack on the rear pan-
el.
RPORT GAIN
Function: Sets the level of the FM signal input
when "FM MOD SOURCE" is set to
"REAR".
Available Values: 0 - 100
Default Setting: 50
87