Table of Contents
Advertisement
Installation
The following topics are covered in this chapter:
•
•
•
•
•
•
•
ATTENTION:
UL Guidelines
1.
2.
Installation Instructions
Depending on the model, the Extenders can be mounted into furniture, a wall, an
Ackermann floorbox (see ackermann.co.uk), or an Extron HSA 400 Series or HSA 800
Series enclosure. Installation involves the following main steps:
1.
2.
3.
4.
5.
For Extender AKM MAAP mounting instructions, see the AKM MAAP Installation Guide.
ATTENTION:
For Extender AAP EX mounting instructions, see the user guide or installation guide for the
appropriate model of HSA Hideaway Surface Access enclosure.
NOTE: The Extender AAP EX does not require a wall box if it will be installed into an
UL Guidelines
Installation Instructions
Preparing the Site and Installing the Wall Box
Front Panel Features and Cabling
Top, Rear, Bottom Panel Features
Mounting
Application Diagrams
Installation and service must be performed by authorized personnel only.
This product should be used with a UL listed electrical box (see "UL Guidelines,"
below).
The Extender must be installed in an Underwriters Laboratories (UL) Listed junction
box. The UL approved electrical wall box (junction box) is not included with the unit; the
installer is responsible for obtaining and installing the box.
The unit must be installed with accordance with the National Electrical Code and with
local electrical codes.
Prepare the site, run cables, and install a wall box or floor box.
Cable rear panel connectors and set the gain switch.
Test the Extender.
Mount the Extender.
Attach input cables to the front panel.
The Extender must be installed in a UL listed wall box, which the installer
is responsible for obtaining.
Extron HSA 400 Series or HSA 800 Series surface access product. If you install an
Extender AAP EX without an HSA, you must use a wall box.
Extender Series • Installation
3
Advertisement
Table of Contents
