Extron electronics Extender AAP User Manual page 16

To replace the standard faceplate with a customized faceplate:
1. Set the line driver in an accessible place (do not do this while
the line driver is installed in a wall or furniture), and remove
the faceplate screws and the jack screw nuts on either side of
the PC Input connector.
2. Fasten the new faceplate to the line driver with the faceplate screws.
3. Reattach the jack screw nuts.
Power and signal LED — This LED (see
B
amber to indicate that the Extender is receiving power
•
green to indicate that an active sync signal is present at the input and the Extender
•
is receiving power
NOTE: The LED remains lit amber when the input signal is HDTV component video,
RGsB, or RsGsBs.
Audio input connector — Plug a 3.5 mm stereo plug
C
figure
into this jack (see
input. Wire the male plug as
shown in the figure at right.
RGB video input connector (Computer In) — Attach a cable from the computer to the
D
Extender via this female 15-pin HD connector (see
Opening for Architectural Adapter Plates (AAPs) — The Extender WM AAP can
E
have up to four optional adapter plates attached here (see
The adapter plates allow for a variety of types of audio/video connectors or another
device such as the Extender AAP to be added to the faceplate.
Blank plates are included with the Extender WM AAP and Extender AKM MAAP to
cover unused spaces.
Other adapter plates must be ordered separately. They also must be attached to the
faceplate and cabled before the line driver is installed in the wall or furniture. The screws
needed for installing the adapter plates are built into the plates, so no additional screws
are needed.
1. Remove the blank plates from the Extender
by unscrewing the nuts that fasten the
plates to the faceplate.
2. Insert the adapter plate screws through the
holes in the faceplate. Attach the adapter
plates to the faceplate with the provided
captive washers and #4-40 nuts.
3. Attach the output cables to the rear
connectors of the adapter plates. Soldering
is required for some connectors. Attach foil
and braided shields to ground connections.
figure 4,
4,
) for unbalanced audio
C
figure
Extender Series • Installation
Jack Screw Nuts
, on the previous page) lights:
B
Tip (L)
Ring (R)
Sleeve ( )
3.5 mm Stereo Plug Connector
(unbalanced)
4, ).
D
figure 4, ) at one time.
E
A U
D IO
IN
C O
M P
U T
E R
I N Adapter Plate
#4-40 Nut with
Captive Washer
E X
T E
N D
E R
W M
A A
P
Extender WM AAP
(up to 4 plates)
8