Extron electronics Extender AAP User Manual page 19

Extender WM AUS is shown
at right wired for
balanced audio output.
The circuit board
configuration is
the same for the
Extender MK,
Extender AAP,
Extender AAP EX,
and
Extender AKM MAAP.
Extender WM is shown below wired for balanced audio output. The circuit board
configuration is the same for the Extender WM AAP and the Extender D.
(5 mm) max.
Do not tin the wires!
RGB video output connectors (see
B
cables from the Extender to the display device via these female BNC connectors. These
BNCs are on pigtail wires secured to the Extender by tie wrap.
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT connect the
sleeve(s) to the
negative (-)
contacts.
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT connect the sleeve(s)
to the negative (-) contacts.
Power
12 VDC
figure 5, , page 10) — Attach coaxial
B
Extender Series • Installation
NO Ground Here
Right Tip
Sleeve(s)
NO Ground Here
Left Tip
Audio
Unbalanced Output
Right Ring
Right Tip
Sleeve(s)
Left Ring
Left Tip
Balanced Output
Right Ring
Right Tip
Sleeve (s)
Left Ring
Left Tip
Power
12 VDC
(5 mm)
max.
Do not tin the wires!
NO Ground Here
Right Tip
Sleeve (s)
NO Ground Here
Left Tip
Audio
Unbalanced Output
Right Ring
Right Tip
Sleeve (s)
Left Ring
Left Tip
Balanced Output
Right Ring
Right Tip
Sleeve (s)
Left Ring
Left Tip
11