Extron electronics Extender AAP User Manual page 20

Power connector (see
C
12 VDC power supply to this 3.5 mm, 2-pole direct insertion
captive screw connector. Wire the connector as shown at right.
Polarity is not important.
ATTENTION: For best results and to reduce the risk of short circuits, trim just
3/16 inch (5 mm) of the jacket from the wires. Do not tin the wires.
Gain switch (see figure
D
At right: Extender MK,
Extender AAP
and
Extender AKM MAAP
gain switch location
(access from the rear)
At right: Extender WM
and Extender WM AAP
gain switch location
(access from the side)
At right: Extender D gain switch
location (like the Extender WM
switch, but accessible from the
front)
To compensate for cable resistance and capacitance, use a small screwdriver to slide
this switch to select the level of video gain that yields the sharpest, smear-free picture.
Normal — unity gain (no signal boost)
•
Medium — mid-level peaking and gain
•
Maximum — maximum amount of peaking and gain. Select this for use with longer
•
cables.
NOTE: Adjust the gain before installing the Extender into a wall, furniture, or
equipment, as the gain switch will be inaccessible after installation.
figure 5, , page 10) — Connect a
C
5, ) —
C
Circuit
board
AUDIO IN
COMPUTER IN
Extender Series • Installation
–
+
(5 mm) max.
Do not tin the wires!
D
Medium – Mid-level
peaking and gain
Maximum Normal
Max. peaking Unity
and gain gain
D Faceplate
Medium – Mid-level
peaking & gain
Maximum Normal
Max. peaking Unity
& gain gain
Circuit
board
Normal –
Unity gain
Medium –
Mid-level
peaking
and gain
D
Maximum –
Max. peaking
and gain
12