Split Windshield (Clip-On Type) - Cushman HAULER 800X Technician's Repair And Service Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

SPLIT WINDSHIELD (CLIP-ON TYPE)

Clip-on type windshield is used on vehicles with tubular
struts. Windshield is secured to front strut with tube
clamps, sleeves and grommets.
Tool List
Plastic faced mallet ..................................................... 1
Wrench, 7/16".............................................................. 1
Phillips screwdriver...................................................... 1
Remove protective covering from the windshields (1, 2).
Fix the tube clamps (8) on the front strut, align the exist-
ing holes on lower windshield (1) with tube clamps (8) as
shown. Insert isolator grommets (3) to small hole
located at bottom of the upper windshield (2). Place
grommets (13) at grooves located at bottom of the lower
windshield (1). Insert pan head bolt (10) through washer
(12), fastener grommet (9) and existing hole in the tube
clamp (8) mounted on front strut. Secure with washer
(12) and lock nut (11). Do not overtighten or squeeze
A
Warning
Decal
1
Qty.
4
VIEW A
2
10
4
B
14
C
5
Fig. 4 Split Windshield (Clip-On Type)
Repair and Service Manual
WEATHER PROTECTION
the fastener grommet (9). Place grommet (13) at bottom
of the windshield as shown and press the sleeve (14)
starting at the grommet, onto the front strut so that it
snaps into place.
Repeat for other side of windshield.
Swing the top section of windshield (2) up and secure by
hooking the upper round latch (4) on each side of strut
to the upper windshield (2). Using a plastic faced mallet,
gently tap the latch (4) to ensure windshield seats prop-
erly. To secure windshield when lowered, press edge of
windshield firmly into lower latches (5).
Take care not to warp windshield when raising and low-
ering the top section of windshield.
Strut
2
12
9
VIEW B
VIEW C
3
8
11
12
13
Front of Vehicle
Page Q-5
B
B