Cushman HAULER 800X Technician's Repair And Service Manual page 167

Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
REAR SUSPENSION
Cupped Shock Washer
Rubber Shock Bushing
Front of the Vehicle
Shock
Absorber
U-Bolt
Rear Axle
Upper
Spring
Plate
Front
Bushing
For Hauler 800X
General
NOTICE
In the following text, there are references to removing/installing
bolts etc. Additional hardware (nuts, washers etc.) that are
removed must always be installed in their original positions
unless otherwise specified. Non specified torques are shown
in the table contained in Section "A".
The rear suspension consists of the leaf springs, shocks
and the hardware that connects these items together,
mounts the springs to the axle and to the vehicle frame.
The removal of the rear axle is covered in the section in
this book titled REAR AXLE.
Shock Absorber
Tool List
Wheel Chocks ............................................................. 4
Jack Stands ................................................................. 4
Floor Jack.................................................................... 1
Frame
Spacer
Bushing
Leaf Spring
Upper Spring
Plate & Bumper
Mount
Lower
Spring
Plate
Fig. 1 Rear Suspension
Qty.
Repair and Service Manual
REAR SUSPENSION
For Hauler 1200X, Shuttle 4x
Shackle Plate
Bumper
Stop
Wrench, 1/2" ................................................................1
Insulated Wrench, 9/16"...............................................1
Wrench, 3/4" ................................................................1
Socket, 1/2" .................................................................1
Socket, 9/16" ...............................................................1
Deepwell Socket, 9/16" ...............................................1
Extension, 3"................................................................1
Ratchet ........................................................................1
Torque Wrench, ft. lbs..................................................1
To reduce the possibility of personal injury, fol-
low the lifting procedure in section 'B' of this
manual. Place wheel chocks in front and
behind the front wheels and check the stability
of the vehicle on the jack stands before start-
Front of the Vehicle
Page N-1
B
B