Wheel Installation; Fig. 1 Wheel And Tire Installation - Cushman HAULER 800X Technician's Repair And Service Manual

WHEELS AND TIRES
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
B

Wheel Installation

Do not tighten lug nuts to more than 85 ft. lbs. (115 Nm)
torque.
It is important to follow the 'cross sequence' pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
Page D-2
NOTICE
Tire style may vary
1
4

Fig. 1 Wheel and Tire Installation

Repair and Service Manual
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts as shown.
Then, tighten lug nuts to 50 - 85 ft. lbs. (70 - 115 Nm)
torque in 20 ft. lbs. (30 Nm) increments following the
same pattern.
ITEM NO
1
3
3
2
5
'Cross Sequence'
TORQUE SPECIFICATION
50 - 85 ft. lbs. (70 - 115 Nm)
1
Valve Stem Cap
1
4
2