Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Starter/Generator
F2
Frame
To Magneto
Direction Selector
Do not arc spark plug wire to ground. Connect to a
known good spark plug and ground plug to a clean metal
surface (muffler, cylinder, etc.). Permanent damage may
be caused to the coil or ignitor if the plug is not grounded
Electrical
Controller
Frame
Hour
Meter
Accelerator
Pedal
Fuel Gauge
Fig. 2 Electrical System (Physical Location)
Repair and Service Manual
Voltage
Regulator
Reverse
Buzzer
Battery
KEY
Switch
properly.
If the engine will not run, but the starter will turn the
engine, proceed as follows:
1. Check for loose terminals, wires and connections.
2. Check for an electrical discharge through the spark
plug wire as follows: Using a spark plug that is known
ELECTRICAL
Solenoid
Relay
Page L-3
B
B