Cushman HAULER 800X Technician's Repair And Service Manual page 173

Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
For further axle information, see Four Cycle Transaxle
Shop Rebuild and Service Parts Manual.
Refer to REAR SUSPENSION section for axle removal.
NEUTRAL LOCK
To prevent the driven clutch from turning the rear wheels
during service operations and to prevent wear to the belt
while being towed, a neutral lock is located on the direc-
tion selector.
The neutral lock is located on the direction selector. To
operate neutral lock located on the direction selector,
first turn the key switch to 'OFF', place direction selector
in 'R' and remove seat. Pull out (1) and rotate(2) the
neutral lock pin handle so that the pointed portion of the
handle is over the side of the direction selector cam
(Ref. Fig. 2). Move direction selector lever towards the
area between 'F' and 'R'. During that motion, the pin will
snap into the hole in the direction selector mounting
bracket, preventing any movement of the lever. When in
this position, the direction selector remains locked in the
neutral position. To activate the direction selector, pull
the neutral lock pin handle out and rotate until the
pointed portion of the handle fits into the hole (3) in the
direction selector cam.
Spring loaded mechanism. To prevent possibil-
ity of fingers becoming pinched in the direction
selector mechanism, hold direction selector
lever when releasing neutral lock pin handle.
2
1
Fig. 1 Neutral Lock (Direction Selector)
3
Repair and Service Manual
REAR AXLE
The rear axle is provided with a lubricant level check
plug located on the driver side at the rear of the housing
(Ref. Fig. 2). Unless leakage of rear axle lubricant is evi-
dent, an annual lubricant check is sufficient.
Checking the Lubricant Level
Tool List
Socket, 13 mm.............................................................1
Ratchet ........................................................................1
Funnel..........................................................................1
NOTICE
For Vehicles with LSD axle, add 2 ounce of friction modifier
during refill.
Clean the area around the check and fill plugs. Remove
the check plug. The correct lubricant level is just below
the bottom of the threaded hole. If lubricant is to be
added, remove the fill plug and add lubricant using a
funnel. Add lubricant slowly until lubricant starts to seep
from the check plug hole. Install the check plug and the
fill plug. In the event that the lubricant is to be replaced,
a drain plug is provided at the bottom of the differential
housing. Capacity of axle is 51 ounces (1.5 liters).
Fill / Check Plug
Drain Plug
Fig. 2 Add, Check and Drain Rear Axle Lubricant
REAR AXLE
B
Qty.
Page P-1
B