Split Windshield - Cushman HAULER 800X Technician's Repair And Service Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

SPLIT WINDSHIELD

Tool List
Plastic faced mallet ..................................................... 1
Wrench, 7/16" ............................................................. 1
Phillips screwdriver ................................................... 1
Remove protective covering from the windshield (2)
(Ref. Fig. 2).
Install sash (3) on each side of the lower section of
windshield. Using a plastic faced mallet, gently tap sash
to ensure windshield seats properly (See Detail A).
Insert bolt (4) through washer (5), rubber grommet (6)
and existing hole in front strut. Secure with washer (5)
and lock nut (7) (See Detail B). Do not over-tighten or
squeeze grommet.
Place bottom section of windshield on rubber grommets
and press the sash, starting at the bottom, onto the front
strut so that it snaps into place (See Details B and C).
Repeat for opposite side of windshield.
Position top grips (8) as shown (See Detail D) at top
hole on each side of front strut. Secure with top grip fas-
Qty.
teners (9).
It may be necessary on early production sun tops to drill a
9/32" hole in front face of both sides of front strut approxi-
mately 7" down from top of strut.
Swing the top section of windshield up and secure by
hooking the top grip on each side of windshield around
the strut.
To secure windshield when lowered, press edge of
windshield firmly into bottom grip (Detail B).
Take care not to warp windshield when raising and
lowering the top section of windshield.
DETAIL D
Strut
8
9
Front of
Vehicle
Windshield
Retainer
Fig. 2 Split Windshield
Repair and Service Manual
WEATHER PROTECTION
NOTICE
DETAIL B
2
Rubber
Latch
Strut
3
6
7
5
5
4
Front of Vehicle
Windshield
3
DETAIL A
Windshield
3
DETAIL C
Page Q-3
B
B