Table of Contents
Advertisement
3.10 - SYSTEM DISARMING WITHOUT ALARM MEMORY
To disarm the system, press remote control button "1". The status LED will turn
OFF and disarming will be confirmed by 3 Beeps and 3 flashes of the turn
indicators.
3.11 - SYSTEM DISARMING WITH ALARM MEMORY
If an alarm event occurs while away from the vehicle, it will be signaled on
disarming, by 2 flashes of the turn indicators and 2 Bops.
The last cause of alarm can be identified by observing the status LED and
counting the flashes.
Ignition attempt:
Seat/Topcase
tampering:
Tilt/Shock
detection:
4.0 - PROGRAMMABLE FEATURES
The alarm system is factory preset with some features enabled and others
disabled as detailed below.
Factory settings
Feature
Acoustic signals
Panic a
larm
Tilt sensor
Passive arming
Anti-hijack
Pre-alarm
Self-rearming (anti-distraction)
PAGE 7
Operations such as arming/disarming, system programming, alarm memory
and learning new devices are
and turn indicators).
Optical/acoustic signals can be excluded.
For use in emergency situations. Panic alarms can be triggered as many times
as necessary but at least 5 sec. must elapse between 2 consecutive alarms.
Pressing remote control button "2" will immediately activate the siren and the
turn indicators for approx. 30 sec. To turn off the panic alarm simply press
button "2" again.
The panic alarm can be triggered with either an armed or disarmed system.
When the system is armed, the sensor will trigger an alarm whenever motion is
detected. The tilt sensor can be excluded.
The system can be programmed to automatically arm every time ignition is
turned OFF making sure the vehicle will not be left unprotected.
When ignition is switched OFF, the turn indicators flash once, the status LED
twice and the siren chirps twice to signal the passive arming countdown
The system fully arms (passive arming)
flash of the turn indicators and 2 Beeps will confirm the system is armed. The
LED will also power ON steady.
To interrupt passive arming, turn ignition ON within 35 sec. of turning it OFF.
Lifting the seat/topcase (if protected by a contact switch) during the 35 sec.
Status
arming delay will cause the procedure to interrupt; it will resume once the
Enabled
seat/topcase is closed
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
4.1 - OPTICAL/ACOUSTIC SIGNALS
signaled both acoustically and optically (LED
4.2 - PANIC ALARM VIA REMOTE CONTROL
4.3 - TILT SENSOR
CAUTION
Exclusion is bound to a single arming cycle.
4.4 - PASSIVE ARMING
35 sec. after ignition is turned OFF. A
.
.
PAGE 8
Advertisement
Table of Contents
