Table of Contents
Advertisement
When the last digit is entered, the alarm system "repeats" the entered code
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works properly.
Eventually disconnect the 8-pin connector and reconnect it after a few seconds.
8.0 - SYSTEM PROGRAMMING
The table below applies to the system programmed in "standard configuration".
Every time you enter the programming procedure, the alarm resets to the default settings.
FUNCTION
Exclusion
"
" of arming/disarming optical signals
Exclusion
"
" of arming/disarming acoustic signals
System passive arming
Siren triggered when immobilizer is ON (system disarmed)
Door input - positive
Optical pulse signals (Hazard)
For Gemini only: Turn ignition key
A lack of power during electrical system maintenance, will not affect the programming.
The procedure must always be carried out entirely. Every key rotation disables the selected function
and moves to the next option until the programming procedure is completed.
8.1
This function activates the optical signals (turn indicator flashes) that confirm system
arming/disarming
(signals are factory disabled).
If the vehicle already has optical lock/unlock signals, the turn indicators alarm flashes
!
8.2 -
This function activates the acoustic signals (siren chirp) that confirm system arming/disarming
(signals are factory disabled).
8.3 - PASSIVE ARMING
This function arms the system 60 sec. after ignition is switched OFF and the last door is opened and
closed. If a door is opened during this lapse of time, the procedure is interrupted; it resumes when the
door is closed.
PAGE 12 - INSTALLER MANUAL
1 FLASH AND A
SHORT PAUSE
10 FLASHES AND A
SHORT PAUSE
3 FLASHES
STATUS
Enabled
Enabled
Disabled
Disabled
Disabled
Enabled
-----
- OPTICAL SIGNALS
should be disabled.
ACOUSTIC SIGNALS
.
8.4 -
SIREN TRIGGERED WHEN IMMOBILIZER IS ON WITH SYSTEM DISARMED
When the system is disarmed, this function triggers the siren as a warning that the immobilizer is ON
and the engine cannot be started. Therefore if ignition key is cycled ON when the immobilizer is armed
the siren will sound until ignition is switched OFF.
This function modifies the alarm input signal (positive or negative) based on the signal generated
the door switch.
8.6
-
This function activates the optical signals based on the connections made.
NB:
Only for vehicles where hook-up is to the Hazard warning lights.
Optical signals activated by connection to the Hazard switch ONLY turn ON during an
!
In this case, do not connect the alarm ORANGE wires to the turn indicator wires.
If this function is disabled, the BLUE wire will carry a negative signal during an alarm cycle.
LED FLASHES
Here below is an example that illustrates the various steps to modify the programmable functions
As mentioned before, every key cycle disables the functions, while the touch key enables them.
Two different tones will sound depending on the action taken and the LED will flash according to the
selected function (see par. .0).
With the system disarmed, turn ignition key "ON" and, while the LED is ON, touch the key to its
Two acoustic signals (a Beep and a Bop) and two flashes of the turn indicators will acknowledge that
the system has entered in programming mode.
8.5
- DOOR SWITCH POLARITY SELECTION
HAZARD WARNING LIGHTS or NEGATIVE OUTPUT DURING ALARM
alarm condition.
The alarm BLUE wire MUST be connected to the Hazard switch.
9.
0 -
SYSTEM PROGRAMMING EXAMPLE
8
receptacle.
by
.
ON
INSTALLER MANUAL - PAGE 13
Advertisement
Table of Contents
