Table of Contents
Advertisement
8.0 - SYSTEM PROGRAMMING
The table below applies to the system programmed in "standard configuration".
Every time you enter in programming mode, the alarm system resets to the default settings.
A lack of power during electrical system maintenance, will not affect the programming.
FUNCTION
Arming/disarming optical signals
Arming/disarming acoustic signals
S
System passive arming
Door input - positive
Double pulse unlock
8.1 - OPTICAL SIGNALS
This function activates the optical signals (turn indicator flashes) to confirm system arming/disarming
operations.
If the vehicle already has optical lock/unlock signals, the turn indicators alarm flashes
!
8.2 - ACOUSTIC SIGNALS
This function activates the acoustic signals (siren chirps) to confirm system arming/disarming
operations.
8.3 - PASSIVE ARMING
This function arms the system 60 sec. after ignition is switched OFF and the last door is opened and
closed.
Opening a door during the 60-second passive arming countdown
interrupt; it will resume once the door is closed
8.4 - DOOR SWITCH POLARITY SELECTION
This function modifies the alarm input signal (positive or negative) according to the signal generated
by the
door switch.
8.5
- DOUBLE PULSE UNLOCK
If this feature is enabled, 2 unlocking pulses will be supplied to unlock all doors at the same time.
This is useful in case separate actions are required to open the driver door and then the other doors.
DOUBLE PULSE UNLOCK QUICK ACTIVATION:
- Disconnect the alarm system power supply and ground the Green/Black wire.
- Connect the alarm power supply; 3 quick high-pitched chirps will confirm operation.
- Remove the Green/Black wire from ground.
NB:
To reset the default setting, repeat the above steps; 1 low-pitched chirp will confirm the operation.
PAGE 10 - INSTALLER MANUAL
STATUS
LED FLASHES
Enabled
Enabled
Disabled
Disabled
Disabled
should be disabled.
will cause the procedure to
.
9.0 - SYSTEM PROGRAMMING EXAMPLE
Press Gemini remote control button "ON" to enable a programmable function and
To enter in programming mode proceed as follows:
• With the alarm system disarmed, turn ignition key "ON".
• Wait approx. 2 sec. for the LED to light up.
• While the LED is ON, press remote control button "1".
A quick
high-pitched chirp,
a long low pitched chirp and 2 flashes of the turn indicators will confirm the
system is in programming mode.
Press once
A quick high-pitched chirp will confirm operation.
ON
OFF
The LED will flash according to the selected
Press once
A long low-pitched chirp will confirm operation.
The LED will flash according to the selected
In both cases, the system will move on to the next function.
Repeat the above steps to enable or disable other functions.
When the last function is programmed, in addition to the confirmation tone, to
the programming procedure,
the system gives 2 low-pitched chirps, 1 high-pitched chirp and the
turn indicators flash twice.
button "OFF" to disable it.
BUTTON "ON"
to enable the
function.
OR
BUTTON "OFF"
to disable the
function.
INSTALLER MANUAL - PAGE 11
Beep
Boop
indicate the end of
Advertisement
Table of Contents
