Table of Contents
Advertisement
This function allows to permanently exclude all acoustic signals. See the
relative paragraph for programming.
If enabled, the PANIC ALARM function allows the user to deliberately activate
the optical/acoustic alarm signals by pressing remote control button 2.
This function works regardless of whether the alarm system is "ON" or "OFF".
The alarm signals last up to approx. 30" but can be silenced by pressing button
2 again. During the alarm signals, the LED will be ON steady.
There is a 5" interval between one panic alarm cycle and the next.
If during programming, the PANIC function has been disabled, pressing button
2, when the alarm is armed or disarmed, will activate the BOOT RELEASE
function. There will be no confirmation signal if the alarm is disarmed but, if the
alarm is armed, the turn indicators will flash once and the LED will turn ON
steady. If the boot is released while the alarm is armed, there will be a 60" delay
time for loading/unloading without triggering an alarm. After the delay time, the
LED will turn OFF. Pressing button 2, resets the alarm in security mode before
the end of the 60" delay. The LED will immediately turn OFF.
During the arming delay, button 2 cannot be used to release the boot
because it is used to exclude volumetric sensors and comfort feature.
This function activates the alarm system if a voltage change occurs in the
vehicle electrical circuit (ex. lamp switching on).
Before enabling the absorption sensor, check out the rules in force
! !
8.4 - ANTI-DISTRACTION REARMING AND AUTO LOCK
This function prevents the vehicle from being unintentionally left unprotected if,
after the system is armed, it is accidentally disarmed by pressing button 1. The
system automatically rearms if no other activity is detected within 35 sec. (ex.
door opening, ignition ON). A flash of the turn indicators will confirm self-
rearming. If a door is opened after disarming, the function will be disabled.
The anti-distraction function activates the CDL control. Therefore, in order to
prevent involuntary activation of the alarm system, the driver door switch
MUST be connected to the GREEN/BROWN alarm wire.
The door-lock security function automatically locks all doors 20" after ignition is
turned ON. All doors will automatically unlock when ignition key is turned OFF.
To prevent accidental activation, the system continuously monitors the ignition
key status and DOOR/BOOT SWITCH inputs. It will not allow doors to lock if the
DOORS and BOOT are manually opened after ignition has been turned ON.
8.0 - PROGRAMMABLE FUNCTIONS
8.1 - ACOUSTIC SIGNALS
8.2 - PANIC ALARM OR BOOT RELEASE
8.3 - CURRENT ABSORPTION SENSOR
in your country regarding noise pollution.
PAGE11
Hide quick links:
Advertisement
Table of Contents
