GCC Technologies LaserPro C180II User Manual page 95

Rotary Fixture (Paper Page) [DEFAUL T SETTING: Unselected]
NOTE
This option is only to be used with the Rotary Attachment optional accessory properly
set up. For instructions on how to set up the Rotary Attachment, please refer to Chapter
VII of this manual.
You will need to select the option when processing a job with the optional rotary attachment system
to engrave on rounded or cylindrical objects. When you have your material and rotary attachment
properly set up:
1) Check the Rotary Fixture function and notice the change in the Paper Size fields. Under Paper
Size, the X value represents the length of your work piece. Enter the length of your work piece in
this field.
2) Under Paper Size, the Diameter value represents the diameter of your working piece (at the
position you wish to engrave). Enter the diameter of your work piece in this field. Again,
remember the proper diameter value would be the diameter location, at the point of engraving
on your work piece.
3) Under Rotary Parameter, the Offset value represents distance from the open end of your
work piece to the base of the padded rubber wheel. This value will be displayed on the
C180II's LCD panel. Enter the proper offset value in this field.
95 232001840G(08)