GCC Technologies LaserPro C180II User Manual page 70

Others Page
The Others Page allows you to change various settings that correspond to the control panel. The
Language setting will allow users to change available languages displayed on the control panel.
The Unit setting will allow you to change whether the units displayed by the control panel is in the
metric or imperial system. The EOF (end of file) Alarm setting will enable or disable an audible
notification when jobs are complete. The Air Delay setting allows you to specify the delay in
seconds of the SmartAIR air-assist after the point of laser firing.
• Language: ENGLISH (others dependent on Firmware)
• Unit: METRIC / ENGLISH
• EOF Alarm: YES / NO
• Air Delay: 1-100 seconds
T ip
Relevant Buttons
F1 (Back)
F4 (Save)
/ Directional
/ Directional
Start / Stop
Auto Focus
/ Manual Focus Buttons
70
Depending on the material you are engraving with, your laser settings, and the
desired results, please experiment with the air delay to achieve your desired
results.
Others Page
Back to previous page
Save your current settings
Scroll through the menu selections
Adjust the value for that selection
Back to Main Work Page
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
Navigating to this page:
Main Work Page
press F4
Functions Page
Select<Ma chin e
Se tting
Machine Setting Page
Select<O th e rs >
from the menu
Others Page
Function
232001840G(08)
>from the menu