GCC Technologies LaserPro C180II User Manual page 52

SmartCENTER Page
Under SmartCENTER mode the job will begin after the system positions the carriage to the center
position between two points or four points indicated by the user. The SmartCENTER mode has to be
enabled through the driver.
Enter SmartCENTER page by pressing the F3 button.
the position points. The positions can be indicated by moving the carriage by hand and pressing
enter to save the positions indicated by the red pointer. After all points are set, the carriage will move
to the center of the stored positions and the job will begin.
Re l e v a nt Buttons
F1 (Back)
F2 (Reset)
F4 (Save)
Auto Focus
▲/ ▼ Manual Focus Buttons
52
You will be prompted to indicate and store
S m a rt CENTER Pa g e
Back to previous page
Reset all saved positions
Save current lens carriage position
Initiate the auto focus function
Manually adjust the height of the work table (Z-axis)
Navigating to this page:
Main Work Page
Main Work Page
press F3
SmartCENTER Page
F unction
232001840G(08)