GCC Technologies LaserPro C180II User Manual page 120

3) Connect a ¼" tubing to the air tube fastener valve on the air compressor.
NOTE
It is important that the ¼" air tubing has clean, straight cuts on each end. Jagged or
slanted cuts will not produce adequate sealing capabilities.
4) Take the unattached end of the ¼" air tubing (other end already connected to air compressor)
and connect it to the air tube connector on the air assist valve. Make sure you press down on the air
tube fastener when inserting the ¼" air tubing, to form a tight, secure attachment as indicated in the
diagram below.
Air Flow Regulator:
Turn Clockwise to
increase airflow
Turn Counter- Clockwise
to decrease
5) Both the Air-Assist Valve and AC Power Sockets are located on the rear side of laser system.
Air Assist Valve
6) Plug the air compressor's power cord A into the AC internal power socket.
7) Plug the female end of power cord B to the AC power socket on laser system and the male end to
an external power outlet.
Congratulations, you have finished setting up the air compressor. Make sure you have the proper
SmartAIR nozzle installed (depending on your application), before you turn on and utilize the air
compressor.
OPERATION:
Switch on the air compressor unit and make sure that the airflow regulator on the air assist valve is
opened (turn clockwise to increase the airflow, counter-clockwise to decrease the airflow). The air nozzle
under the laser head should emit a steady flow of air.
With the SmartAIR nozzle and air compressor properly installed and operating, all configurations and
settings relating to air-assist functions are controlled through the LaserPro print driver and hardware
control panel. Please refer to the LaserPro Spirit GLS PEN page on print driver section of this manual
for details on how to enable and configure air-assist functionality.
120
Power Sockets are located on the r
Air Tube Fastener
Air Tube Connector
Power Socket
232001840G(08)