GCC Technologies LaserPro C180II User Manual page 124

OPERATION MENU:
After hardware installation, please enter the function menu on the control panel to enable the
SmartGUARD fire alarm.
SmartGUARD Enable / Disable:
Press directional key (left or right) to enable the SmartGUARD device or disable it.
Sensitivity:
Press directional key (left or right) to set the sensitivity of SmartGUARD. There are five sensitivity
settings (1,3,5,7,9 seconds) that can be selected. Sensitivity defines the time from when a fire is
detected until the fire alarm alerts user of fire and automatically shuts down the laser from firing.
For example, if the sensor delays switch is set to the 3-second position, the SmartGUARD will start
an alarm and automatically stop laser firing after detecting a fire for 3 seconds.
124
Connect the cable shown
Navigating to this page:
Main Work Page
press F4
Functions Page
Select< Adv a nc e d
O ptions >from the
Machine Setting Page
Select<S m a rt GU A RD
Se tting > from the menu
SmartGUARD Setting Page
232001840G(08)