GCC Technologies LaserPro C180II User Manual page 127

3) Prepare the graphic you would like to engrave with the rotary attachment and go to the Paper
Page of the C180II print driver.
4) On the Paper Page, the first thing you must do is to check the Rotary Fixture. The Paper Size
options and Rotary Parameter will change to allow for proper input based on your rotary
attachment.
a) Under Paper Size, the X value represents the length of your working piece. Enter the
length of your work piece in this field.
b) Under Paper Size, the Diameter value represents the diameter of your working piece
(at the position you wish to engrave). Enter the diameter of your work piece in this field.
Again remember the proper diameter value would be the diameter location on your
work piece you will be engraving.
c) Under Rotary Parameter, the Offset value represents distance from the open end of your
work piece to the base of the padded rubber wheel. This value will be displayed on the
LCD panel. Enter the proper offset value in this field.
5) Your C180II print driver settings are now property set. Manually position the laser carriage to the
proper X / Y location on the object you will be engraving and position the auto focus pin over the
area to be engraved on your work piece. Hit the Auto Focus button and the LaserPro C180II
will now properly focus at the location to be engraved.
6) Go back to the print driver to print your design and let the engraving begin.
NOTE
The maximum diameter and length of the to-be-engraved object is as follows:
Small conical fixture: 50 mm and 250 mm.
Big conical fixture: 127 mm and 250 mm.
Maximum weight should not exceed 3kg.
Exchanging the conical fixtures on the rotary attachment:
A. Remove the 2 screws shown in the picture below.
127 232001840G(08)