GCC Technologies LaserPro C180II User Manual page 73

SmartGUARD Page
After optional SmartGUARD hardware installation, please enter the function menu on the control
panel to enable the SmartGUARD fire alarm. Note SmartGUARD fire alarm system is not a fire
extinguisher, but an fire detecting and alarm system.
SmartGUARD Enable / Disable:
Press directional key (Left or Right) to enable the SmartGUARD device or disable it.
Sensitivity
Press directional key (left or right) to set the sensitivity of SmartGUARD. There are five sensitivity
settings (1, 3, 5, 7, 9 seconds) that can be selected. Sensitivity defines the delay time from when
a fire is detected until the fire alarm alerts user, and automatically stop laser firing. For example, if
the sensor delay switch is set to the 3-second position, the SmartGUARD will start an alarm and
automatically stop laser firing after detecting a fire for 3 seconds.
Stow Carriage
This function will decide if the lens carriage stay in the last position (set to <NO>) or move to the
opposite direction (up or down) when fire alarm is initiated. The default is <YES>, the lens
carriage will move to opposite direction when a fire detected.
Relevant Buttons
F1 (Back)
F4 (Save)
/ Directional
/ Directional
SmartGUARD Setting Page
Back to previous page
Save your current settings
Scroll through the menu selections
Adjust the value for that selection
73
Navigating to this page:
Main Work Page
press F4
Functions Page
Select<
O ptions
Advanced Option Page
Select<S m a rt GU A RD>
from the menu
SmartGUARD Page
Function
232001840G(08)
Adv a nc e d
>from the