Siemens SINUMERIK 802D sl Programming Manual page 85

04.07
Tool radius too wide for inside machining
In such cases, machining of the contours is performed only as far as is possible
without causing damage to the contour.
Fig. 3-26
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
Tool radius too wide for insiede machining
Movement Control Commands
3.5 Tool offset functions
3-85