Exact Stop (G09, G61), Cutting Mode (G64), Tapping Mode (G63) - Siemens SINUMERIK 802D sl Programming Manual

Movement Control Commands
3.4 Cutting feedrate control
3.4.3

Exact stop (G09, G61), cutting mode (G64), tapping mode (G63)

Cutting feedrate can be controlled, as indicated in the table below.
Table 3-9
Designation
Exact stop
Exact stop mode
Cutting mode
Tapping mode
Format
G09 X... Y... Z... ; Exact stop
G61 ;
G64 ;
G63 ;
3-72
G code
G09
G61
G64
G63
Exact stop mode
Cutting mode
Tapping mode
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
Validity of G code
Valid only in the Deceleration and
block where speci- stop at the end point
fied of the block, position
check prior to pro-
ceeding to the next
block
Modal G code, Deceleration and
remains effective un- stop at the end point
til G62, G63, or G64 of the block, position
is specified. check prior to pro-
ceeding to the next
block
Modal G code, No deceleration to
remains effective un- the end point of the
til G61, G62, or G63 block prior to pro-
is specified. ceeding to the next
block
Modal G code, No deceleration to
remains effective un- the end point of the
til G61, G62, or G64 block prior to pro-
is specified. ceeding to the next
block,
feedrate override is
not effective
© Siemens AG 2007 All rights reserved
04.07
Description