Siemens SINUMERIK 802D sl Programming Manual page 115

06.01
04.07
Q/R
By all means, specify a positive value at address Q. The sign is ignored if address
Q is specified with a negative value. Q equal 0 is set whenever no lift--off amount is
programmed. This leads to cycle execution without lift--off.
Cancel
G codes of group 01 (G00 to G03) and G87 must not be specified in a single block.
Otherwise, G87 is canceled.
Tool offset
Tool offsets are ignored in the canned cycle mode.
Example
M3 S400;
G90 G0 Z100
G90 G87 X200. Y--150. Z--100. R150. Q3. P1000 F150.;
Y--500.;
Y--700.;
X950.;
Y--500.;
Y--700.;
G80;
G28 G91 X0 Y0 Z0;
M5;
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Rotate spindle
Position, bore hole 1,
orient at the initial level, then shift by 3 mm,
stop at point Z for 1 s
Position, drill hole 2.
Position, drill hole 3.
Position, drill hole 4.
Position, drill hole 5.
Position, drill hole 6
Cancel canned cycle
Return to the reference position return
Spindle stop
Enhanced Level Commands
4.1 Program support functions (1)
4-115