Channel-Specific Setting Data - Siemens SINUMERIK 802D sl Programming Manual

04.07
D.4

Channel-specific setting data

42110
SD number
Default setting: 0
Changes effective IMMEDIATELY
Data type: DOUBLE
Meaning:
42140
SD number
Default setting: 0
Changes effective IMMEDIATELY
Data type: DWORD
Meaning:
42150
SD number
Default setting: 0
Changes effective IMMEDIATELY
Data type: DOUBLE
Meaning:
42160
SD number
Default setting: 0
Changes effective IMMEDIATELY
Data type: DOUBLE
Meaning:
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
DEFAULT_FEED
Default value for path feed
Minimum input limit: 0
Protection level: 7/7
If no path feed is programmed in the part program, the value stored in
$SC_DEFAULT_FEED is used.
The setting data is evaluated at the start of the part program allowing for the feed type ac-
tive at the time (see $MC_GCODE_RESET_VALUES and/or $MC_EX-
TERN_GCODE_RESET_VALUES).
DEFAULT_SCALE_FACTOR_P
Default scale factor for address P
Minimum input limit: - -99999999
Protection level: 7/7
This machine data applies in combination with external programming languages.
It is effective with $MN_MM_EXTERN_LANGUAGE = 1.
If no scale factor P is programmed in the block, the value in this
machine data is applied.
DEFAULT_ROT_FACTOR_R
Default angle of rotation R
Minimum input limit: 0
Protection level: 2/7
When commanding coordinate rotation G68 without specifying an angle of rotation, the
value set to this setting data is applied.
EXTERN_FIXED_FEEDRATE_F1_F9
F1 digit feed F1 - - F9
Minimum input limit: 0
Protection level: 2/7
Pre- -defined feedrates which are selected by commanding F1 - - F9 when G01 is active.
Machine and Setting Data
D.4 Channel-specific setting data
Maximum input limit: - -
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: 99999999
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: 360
Unit: degree
Applies with effect from SW version:
Maximum input limit:
Unit: mm/min
Applies with effect from SW version:
D-237