Table of Contents
Advertisement
5. Multiple LED Spheres
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Sphere.
The pins:
3. Link the units as shown in (Fig. 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets.
Do so for all units and the controller.
DMX-Set up
Note : Link all DMX cables before connecting electric power
5. Do not supply power before the whole system is set up and connected properly.
Design your show according to your DMX controller functions.
After switching on, the LED Sphere will automatically detect whether DMX 512 data is received or not.
there is
no data received, the problem may be:
- The XLR cable from the controller is not connected with the input of the LED Sphere.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It's necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
(DMX
control)
1.
Earth
2.
Signal -
3.
Signal +
11
Fig. 4
If
Advertisement
Table of Contents
