Operation; Initial Start-Up; Preparation; Switching The Freeze-Dryer On - Christ Alpha 3-4 LSCbasic Operating Manual

Freeze-dryer Alpha 3-4 LSCbasic

6 Operation

6 Operation
6.1

Initial start-up

WARNING
6.2

Preparation

6.3

Switching the freeze-dryer on

44 / 97
Before the initial start-up, please ensure that your freeze-dryer is properly
set up and installed (see chapter 5 - "Set-up and connection")
The ice condenser chamber must be clean and dry.
•
Remove any water residues from the preceding run.
•
Close the aeration valve and the media drain valve.
•
Ensure that all of the valves of the accessories are closed.
•
Switch the vacuum pump on.
•
Actuate the mains switch.
The control unit performs a self-test and an initialisation. This may take
several seconds.
•
Follow the safety instructions and hazard warnings (see chapter 3 -
"Safety")!
Version 11/2018, Rev. 1.2 of 05/03/2019 • sb-pe
Translation of the original operating manuel