Waste Fluid Container; Guidelines For Software Installation - Agilent Technologies 4100 Site Preparation Manual

Waste Fluid Container

Operation of the Agilent 4100 MP-AES instrument requires the use of
a drain vessel for the disposal of excess fluids and vapors from the
spray chamber. Suitable tubing is supplied with the instrument for
use with inorganic solvents. When using organic solvents, different
drain tubing that is suitable for the solvent in use will be required.
A chemically inert container, not glass, to hold minimum of two liters
(4 pints) of waste must be provided by the instrument user. It should
be located underneath the sample area (or on the right hand side of
the instrument), where it is protected by the bench and in full view of
the operator.

Guidelines for Software Installation

Agilent recommends that you purchase a PC as part of the Agilent
4100 MP-AES instrument package. The PC included in the package
will come with the appropriate operating system as loaded by the PC
supplier.
For instructions on installing the Windows operating system, please
refer to the appropriate documentation supplied with the software. It
is the responsibility of the customer to ensure that the operating
system software has been installed and is functional if the customer
is supplying the PC or the operating system.
Agilent will not assume responsibility for loss of data.
NOTE
The Agilent service engineer will connect the PC to the instrument
and any factory-approved accessories purchased at installation.
Initial instrument software installation and familiarization is also
included as part of the system installation. For information on
installing the MP Expert software, consult the Agilent 4100 MP-AES
User's Guide provided with the instrument.
Agilent 4100 Microwave Plasma Atomic Emission Spectrometer Site Preparation Guide
Laboratory Facilities
35