Description; Overview; Base Components; Table 1-1: Base Components - Siemens SIMATIC ET 200pro Quick Manual

Description

1.1

Overview

1.1.1

Base components

The following table shows the fundamental components required for a configu-
ration with motor starters.
Component
Wide module ... is the mechanical holder in which the rear
holder wall bus modules of the ET 200pro are lined
(for motor up and on which the electronic modules and
starter) motor starter are firmly screwed.
... can be ordered in the lengths 0.5 m, 1 m,
2 m
(see manual Decentralized peripheral sys-
tem ET 200pro).
Interface ... connects the ET 200pro with the PROFI-
module BUS-DP master and prepares the data for
IM 154-. DP the electronic modules and motor starter
standard / connected.
high feature (see manual Decentralized peripheral sys-
tem ET 200pro).
Terminating ... terminates the bus at the last module
module (enclosed with the interface module IM 154-
.).
Rear wall bus ... handles the bus supply, feeds through the
module for supply voltage for the electronics and actua-
motor starter tor control and accommodates:
and special • a special module
modules • a motor starter DSe (standard or high fea-
ture), sDSSte / sDSte
• a reversing starter RSe (standard or high
feature), sRSSte / sRSte
(see

Table 1-1: Base components

SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
Function
Chapter 6).
1
Drawing
1-1