Safety Instructions - Ametek OXYvisor Installation, Operation & Maintenance Manual

Installation, Operation & Maintenance Manual
OXYvisor Optical Oxygen Analyzer
Section 6 - Maintenance / Repair / Service

6.1 Safety Instructions

!
Only use original accessories or original spare parts as described within this instruction.
Observe all relevant installation and safety instructions described in the instructions for the
device or enclosed with the accessory or spare parts.
WARNING
!
If an error message exist: (1) Check the gravity of the error, (2) Correct the error, and (3) If the
device is faulty take is out of operation.
WARNING
!
There is a danger of explosion when carrying out repairs and maintenance on the device in a
hazardous area. Isolate the device from power and ensure the atmosphere is explosion-free
(hot work permit) before opening the analyzer.
WARNING
!
Danger of explosion in areas subject to explosion hazard. Connect the device correctly after
maintenance. Close and seal the device after maintenance work.
WARNING
Technical Assistance
6.2 Maintenance Overview
The OXYvisor analyzer has minimal maintenance requirements. As good practice, from time-to-time it is
recommended to:
• Visually inspect the analyzer and its components for any damage
• Check the Alarm Log for any conditions and take actions if they persist
• Wash the analyzer clean with water to remove any buildups of corrosive components
Maintenance for the BOS oxygen sensors are not covered in this manual. Please consult the BOS
maintenance manual.
6.3 Repairs
The OXYvisor is not intended for field repair less a few minor direct part replacements. The only field
components allowed for replacement are the Rear (Wiring) Compartment lid and the Junction Box.
!
Flameproof joints are not intended to be repaired. For repair or replacement of any part,
contact Barben Analytical.
WARNING
67