Troubleshooting - AEG 10366MM-MN User Manual

22 www.aeg.com
When the cleaning is completed, install
the glass panels and the oven door. To
install the oven door, do the above steps
in the opposite sequence.
4
12.6 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
There is no spark when you
try to activate the spark gen-
erator.
There is no spark when you
try to activate the spark gen-
erator.
There is no spark when you
try to activate the spark gen-
erator.
4
6
5
5
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
Burner cap and crown are
placed incorrectly.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Place the burner cap and
crown correctly.